Need help?Do you have a question about the Brother S-7100A-403 and is the answer not in the manual?
General| Stitch Type | Lockstitch |
|---|---|
| Max Stitch Length | 5 mm |
| Weight | 10 kg |
| Presser Feet | Standard |
| LCD Screen | No |
| Speed Control | Foot Pedal |
| Needle System | DB x 1 |
| Lubrication system | Automatic |
| Needle | DB x 1 |
| Foot Lift | Manual: 5 mm, Knee: 12 mm |
| Application | Light to Medium Weight Fabrics |
Defines safety indications, symbols, and their meanings.
Explains hazard symbols like danger, warning, and caution.
Covers DANGER, WARNING, and CAUTION levels of safety.
Details environmental requirements and installation safety.
Safety advice for operations, cleaning, and maintenance.
Explains various warning labels found on the machine.
Details on speed, stitch length, and components.
Location, carrying, and tilting procedures.
Specifies table dimensions and drill hole locations.
Lists parts for control box and connecting rod installation.
Details on mounting rubber cushions and head rest.
Procedure for attaching the machine head.
Steps to adjust the knee lifter plate for presser foot height.
Instructions for lubricating the sewing machine and oil replenishment.
Steps for connecting operation panel, motor, and power supply connectors.
Instructions for proper grounding of the machine.
Wiring for specific regional specifications.
Procedure for installing cores on wiring.
Connecting power switch and cord for 220V systems.
Wiring for 100V/400V systems including transformer box.
Identifies keys and indicators on the operation panel.
Function of the thread trimming disable key.
Function of the slow start key.
Function of the half stitch key.
How to set and perform start/end backtack stitches.
How to set and perform continuous backtack stitches.
How to change the display mode.
Adjusting the maximum sewing speed.
Adjusting the speed for start backtack stitches.
How to set and operate the lower thread counter.
How to set and operate the thread trimming counter.
How to set and operate the needle replacement counter.
Setting needle up or down stop position.
How to set correction sewing mode.
How to set thread wiping function.
Adjusting the needle up stop position.
Steps to reset all settings to their default values.
Recommended daily cleaning and checks for longevity.
Procedures for replacing fixed and movable knives.
How to adjust the arm thread guide for thread take-up.
Steps to adjust the presser foot to the standard height.
How to adjust the height of the feed dog.
How to adjust the angle of the feed dog.
Steps to set the needle bar to its lowest position.
How to adjust the timing between needle and feed.
How to align the rotary hook with the needle.
Procedure to check oil supply to the rotary hook.
How to adjust the oil supply to the rotary hook.
Common sewing issues like thread tension and skipped stitches.
Problems with uneven seams, thread unravelling, and puckering.
Problems with material slippage and thread breakage.
Problems with incorrect thread trimming.
Issues with broken needles and machine not operating.
Problems with high speed operation and display.
Explains error codes related to machine head position and panel issues.
Error codes related to treadle, motor, and encoder signals.
Error codes related to motor overheating, timeout, and panel communication.
Error codes related to power supply and solenoid issues.
Reference chart for characters displayed on the 7-segment panel.
To Next Page
