To Next Page

To Previous Page

202

POWERHEAD

POWERHEAD DISASSEMBLY

Remove the upper main bearing.

Remove the lower bearing seal housing.

Remove the housing O-ring. Discard O-ring.

Use a punch to remove the housing seal. Discard

seal.

Inspect housing and replace if necessary.

Remove the O-ring from crankshaft sleeve and

inspect it. Replace the O-ring if it is not in good

condition.

1. Upper oil seal

2. Upper main bearing

002034

002042

002044

1. Punch 002053

002040

Questions and Answers:

Need help?

Do you have a question about the BRP EVINRUDE E-TEC E60DPLAA Series and is the answer not in the manual?

BRP EVINRUDE E-TEC E60DPLAA Series Specifications

General