349
TRIM AND TILT
TRIM AND TILT REPLACEMENT
13
Remove one of the locknuts from the angle adjust-
ment rod. Remove the rod from the stern brack-
ets.
Remove the unit from the stern brackets far
enough to remove the ground lead from the pump
motor mounting screw.
75 – 90 HP MODELS
Remove the external snap rings from the upper
pin.
Use a punch to remove the upper pin.
Retract the tilt cylinder rod.
Remove the external snap rings from the lower
pin.
Use a punch to remove the lower pin and remove
the trim/tilt unit from the stern brackets.
18941
1. Ground lead 007640
25064
25065
25077
25076
To Next Page
Loading...
