30
long, it can be shortened by knotting
or looping it. DO NOT cut and re-tie
the tether cord.
NNOOTTIICCEE
CCaarreeffuullllyy cchheecckk tthhee ffuunnccttiioonn ooff aallll
ccoonnttrrooll aanndd eennggiinnee ssyysstteemmss bbee--
ffoorree lleeaavviinngg tthhee ddoocckk..
Move the remote control handle to
NEUTRAL.
DDOO NNOOTT advance the throttle before
start-up. Advancing the throttle over-
rides the electronic idle control
system.
If the outboard is started with the throt-
tle advanced, the outboard will be in a
safety mode.
It will not respond to throttle until the
throttle is returned to slowest IDLE
position.
After the engine starts, the engine
management module (
EMM
) auto-
matically increases idle speed slightly.
Idle speed will decrease as the engine
warms up.
EEnnggiinnee SSttaarrttiinngg
IIMMPPOORRTTAANNTT: If equipped with
Evinrude ICON II
Remote Control
System, refer to .
Turn the key switch to the ON posi-
tion, then:
– SSiinnggllee eennggiinnee aapppplliiccaattiioonnss ——
turn the key fully clockwise to the
START position.
– MMuullttiippllee eennggiinnee aapppplliiccaattiioonnss ——
Push and hold the START button
(s).
1. Key switch START position
TTYYPPIICCAALL ((DDUUAALL EENNGGIINNEE SSHHOOWWNN))
1. Start buttons
Upon start-up, release the key or
buttons.
If the engine did not start, release the
key or button momentarily, then try
again.
Each time the key switch is turned
from OFF to ON, the warning system
will self-test. Refer to
ENGINE
MONITORING
.
OPERATION
To Next Page
Loading...
Need help?
General
