BRP ROTAX 916 i A Series Maintenance Manual

BRP-Rotax
MAINTENANCE MANUAL LINE
CLEANING THE OIL TANK
General note
NOTE
This procedure is optional and requires purging of the oil system. See Chapter
12–20–00 section Purging the oil system. If using leaded fuel it is required to
clean the tank according to the limits mentioned in Chapter 05-20-00, section
Scheduled maintenance checks. It is only necessary to clean the oil tank and the
inner parts if there is heavy oil contamination.
Procedure Procedure to clean the oil tank:
Step
Procedure
1
Detach the profile clamp and remove the oil tank cover together with the O-
ring and the oil lines.
2
Remove safety wire.
3
Remove the inner parts of the oil tank such as the baffle insert and the
partition.
4
Clean oil tank and inner parts and check for damage.
NOTICE
Incorrect assembly of the oil tank components might cause engine faults or en-
gine damage.
Step
Procedure
5
Fit hex. double ignition screw M12x12 with a new gasket ring.
Tightening torque 25 Nm (18 ft.lb).
6
Re-install safety wire.
7
Reassemble the oil tank by following the same steps in reverse order.
8 Purge the oil system.
12–20–00
Page 36
December 01 2023
Effectivity: 916 i A / C24
Edition 0/Rev. 1

BRP ROTAX 916 i A Series Specifications

General

Brand	BRP
Model	ROTAX 916 i A Series
Category	Engine
Language	English