BRP ROTAX 916 i A Series - Page 78

BRP-Rotax
MAINTENANCE MANUAL LINE
INSTALLATION OF PROPELLER GEARBOX
Preparation
NOTICE
No hammering or pressing!
The drive gear must only be pushed on by hand.
NOTICE
Ensure that the friction washer is in the correct installation position.
NOTICE
The dog and drive gears are in pairs.
Only use parts with the same serial number.
• Clean and degrease all parts carefully.
• Remove LOCTITE adhesive residue with LOCTITE 7063.
• Visual inspection of the crankshaft on the power take off side.
• Lock the crankshaft into place. See Chapter 12-20-00 section Locking/Loosen of the
crankshaft
Figure 5.9
1
Crankshaft (power take off side)
2
Drive gear
3 Friction washer VS-30 4 Hex. nut 30 x 1.5
05–50–00
Page 12
December 01 2023
Effectivity: 916 i A / C24
Edition 0/Rev. 1