BRP Ski-Doo OXYGEN - Remote Control Operation

16
B. THE HELMET
15. REMOTE CONTROL
The OXYGEN helmet has been designed to perform at very cold temperatures,
but to keep the performances without compromising the comfort, you can
adjust the heat intensity to the weather conditions.
If the red LED is lighted, this means that a short circuit happened, follow the
steps below:
1.
1.1.
1. Stop your vehicle.
2.
2.2.
2. Unplug your device from your vehicle.
3.
3.3.
3. Look for the root cause of the short circuit.
See the Troubleshooting section of this manual.
Push button
Actuator to change the heat
intensity. Press during 1 sec.
to change the intensity.
Electrical visor ON
Green when your electrical
visor is in function.
Short circuit
Red when a short circuit
happened between the
cont
roller and your helmet.
High: 100%
Maximum intensity, ideal
for very cold conditions.
Medium: 75%
Middle intensity, ideal
for cold conditions.
Low: 50%
Minimum intensity, ideal
for warmer conditions.