30
H. ACCESSORIES AND SPARE PARTS
4. LED UTILITY LIGHT BATTERIES REMPLACEMENT
S
SS
STEP 1
TEP 1TEP 1
TEP 1
Using the Phillips #1 screw driver delivered with the LED Utility Light, remove
the screws on each side of the utility light batteries cover and set them aside.
Note: Be careful not to drop the screws and/or unscrew the utility light screws.
STEP 2
STEP 2STEP 2
STEP 2
Grab one side of the batteries door and gently pull on it. Grab the top of the
batteries cover and pull it out completely.
STEP 3
STEP 3STEP 3
STEP 3
Replace the batteries and make sure that they are well positioned.
STEP 4
STEP 4STEP 4
STEP 4
Put back the batteries cover and gently screw back the screws (0.2 Nm).
NOTICE
NOTICENOTICE
NOTICE
Be sure not to over-torque the screws to avoid any damage.
To Next Page
