BRP Ski-Doo OXYGEN - Heating Visor Haze; Sun Visor Malfunction; Ice Formation on Face Shield Latch; Rear Light Malfunction

26
G. TROUBLESHOOTING GUIDE
PROBLEM ACTION
THE HEATING VISOR
SEEMS HAZY
1. In unusual circumstances, a haze may appear on the surface of the anti-fog coating.
This can be easily removed and never reappear by following these steps:
a. Moisten a soft cloth with warm soapy water.
b. Gently clean and let air dry.
c. Let air dry without trying to rub dry.
d. Repeat if necessary.
2. If the problem is still not resolved, check if the fog seems to be between the two lenses.
If this is the case, go to
your authorized
BRP dealer for detailed inspection.
SUN VISOR
DYSFUNCTIONING
1. Check if the sun visor is installed and positioned correctly on the helmet.
2. Check if there are any broken parts.
Replace them by new ones if necessary.
3. If t
he problem is st
ill not resolved, go to your authorized BRP dealer for detailed inspection.
ICE FORMATION ON FACE
SHIELD LATCH
Make sure your face shield is properly closed.
You should hear/feel a “click”.
2. Make sure you use the breath deflector to reduce water accumulation in this area.
REAR LIGHT
DYSFUNCTIONING
1. Check if the rear light has been damaged.
Replace it if necessary.
2. If the problem is still not resolved, go to your authorized BRP dealer for detailed inspection.
FRONT LIGHT
DYSFUNCTIONING
(SOLD SEPARATELY)
1. Make sure you press the ON button longer than 1 second. To avoid any misuse, there is a 1 second delay before your front
light turns ON.
2. Check if the batteries are still good.
Replace the batteries by new ones if necessary
3. Check if the electrical contacts in the batteries socket are damaged or dirty;
Clean the electrical contacts or replace your front light if necessary.
4. If the problem is still not resolved, go to your authorized BRP dealer for detailed inspection.