6
Click on the Test the connection… button to launch the Serial Commu-
nications Tool.
If your modem is properly connected to the PC, all the status indicators
except DCD should show ✓. To verify that the modem is recognized
enter the letters A and T in the String to be transmitted box and click
on the Enter button. The modem should then reply OK.
If your modem has reacted as described above, you can go on with the
programming of the modem. Enter the commands one bye one from
Table2 into the String to be transmitted box and click on the Enter
button after each command:
All 0 characters on the list are zeros. Please note that this list of com-
mands is only valid for the Multitech modem. It is not guaranteed to
work with other types of modems.
Now the Multitech modem can be connected to the SLM in the field.
Use cable AO0567 which is a straightforward extension cable (male/
To Next Page
Loading...
Need help?
General
