Power Amplifier Type 2719 – User Manual18
RMS Current Monitor – for approximate indication
(also available from BNC connector at back panel with
read-out accuracy ± 2%)
PROTECTION
Input signal is removed and an indicator lamp is lit
when the following parameters exceed preset limits:
Driver Coil Current
– true RMS adjustable limit 1 to
15 A (RMS)
Power Transistor Temperature
Heat Sink Temperature
Output Signal Distortion
– no shut down
OTHER FEATURES
Electronic peak current limiting
POWER REQUIREMENTS
Single phase 100, 120, 230 V RMS, ±10%. Approx.
400 VA at full load
Power insert connector with fuse holder and voltage
selector at rear panel
DIMENSIONS
Height: 2HE equivalent of 88 mm
Width: 482.6 mm (19 in) with flanges for standard
19- inch rack mounting
Depth: 350 mm (13.8 in)
WEIGHT
14.0 kg (31 lb.)
To Next Page
Loading...
Need help?
General
