Copyright 2013, Brüel& Kjær Sound & Vibration Measurement A/S
All rights reserved. No part of this publication may be reproduced or distributed in any form, or
by any means, without prior written consent from Brüel & Kjær Sound & Vibration Measurement
A/S, Nærum, Denmark
Safety Considerations
This apparatus has been designed and tested in accordance with IEC/EN 61010 – 1 and
ANSI/UL 61010 – 1 Safety Requirements for Electrical Equipment for Measurement,
Control and Laboratory Use. This manual contains information and warnings which must be
followed to ensure safe operation and to retain the apparatus in safe condition. Special note should
be made of the following:
Safety Symbols
The apparatus will be marked with this symbol when it is important that you refer to the
associated warning statements given in the manual.
Protective Earth Terminal Hazardous Voltage
Explosion Hazard
The equipment is not designed to be used in potentially explosive environments. It should not be
operated in the presence of flammable liquids or gases.
Warnings
• Switch off all power to equipment before connecting or disconnecting their digital interface.
Failure to do so could damage the equipment
• Whenever it is likely that the correct function or operating safety of the apparatus has been
impaired, it must be made inoperative and be secured against unintended operation
• Any adjustment, maintenance and repair of the open apparatus under voltage must be
avoided as far as possible and, if unavoidable, must be carried out only by trained service
personnel
• Do not dispose of electronic equipment or batteries as unsorted municipal waste
• It is your responsibility to contribute to a clean and healthy environment by using
the appropriate local return and collection systems
• Hazardous substances in electronic equipment or batteries may have detrimental
effects on the environment and human health
• The symbol shown to the left indicates that separate collection systems must be used
for any discarded equipment or batteries marked with that symbol
• Waste electrical and electronic equipment or batteries may be returned to your
local Brüel & Kjær representative or to Brüel & Kjær Headquarters for disposal