Safety
E1400011_1_001
11
2.6.3 Safety When Working with VT Probe Systems
WARNING
Danger of injury due to burns (hot/cold) when working with VT probe systems
The operator may burn their hands or fingers when touching a very hot or cold sample, or
the top of the VT probe.
u Wear protective gloves while handling hot or cold samples.
u Wear protective gloves when working around the VT probe.
u Only trained personnel should be working with the VT probe system.
2.6.4 Safety When Working with Glassware
WARNING
Danger of injury from glassware or ceramics breakage!
Broken glassware or ceramics may cause minor injuries or material damage, but may also
result in a life threatening situation if hazardous substances are used.
u If glassware or ceramics breaks, refer to the corresponding precautions and cleaning/
disinfection instructions.
u Wear protective equipment.
u Perform all tasks with the glassware or ceramics carefully.
u Before carrying out any maintenance work, remove the samples and use dummy
samples if necessary.
u Strictly observe the correct sample adjustment, i.e. the maximum sample height.
u Always transport the glassware or ceramics with the cover, if applicable. Never turn the
glassware or ceramics upside down or on it’s side.
u The laboratory supervisor is responsible for:
ð Establishing and enforcing standard sample handling and cleaning procedures.
ð Establishing and enforcing the use of protective clothing and equipment.
ð Training laboratory personnel.
ð Preparing an emergency plan.
To Next Page
Loading...
Need help?
General
