Combustion chamber linings
Important note: Single cracks on fire-resistant combustion chamber lin-
ings are no reason for concern.
These exactly dimensioned fireclay plates are manufactured specially for
our fireplaces. The pre-fired fireclay plates protect the steel body, have in-
sulating properties and are an essential component of the low-emission
“green” combustion chamber design. Most different temperature strains,
as well as mechanical impacts can (or actually will) cause small cracks on
these plates. This material condition is harmless and does not constitute a
reason for a claim.
What is not normal, are chips of stone falling off, or noticeable, star-shaped
cracks on several levels.
Black / anthracite surface of combustion chamber linings may show color
changes during use. This is a normal, unavoidable process and does not
constitute a reason for reclamation.
If the following points are taken into account, the black colour of the fsur-
face will remain intact for a long time:
- Operation as intended with the recommended filling quantities (surface
temperature of fireclay < 700°C).
- No treated or coated wood, coal or liquid fuels; only natural wood with
residual moisture <20%.
- Do not clean the surfaces with steel/wire brushes or cleaning agents.
Door sealing ropes
BRUNNER is using only high-quality door sealing ropes, which are exactly
adapted to the requirements of our heating devices.
Yet the door sealings are wear parts, and therefore are not covered by our
product warranty.
© 2023 Brunner GmbH User Manual Panorama-Fireplace (1.47) 15
To Next Page
Loading...
