©2004,2002 BRUNO INDEPENDENT LIVING AIDS, INC.®
33
SRE-2700 06-11-2004
The on/off switch is built into the circuit breaker
which is provided to protect the battery,
controller and motor circuits in the Elevator
carriage. It is unlikely that this circuit breaker will
ever “trip” during normal use, but if the Elevator
should fail to operate, check the circuit breaker
and reset it if necessary. If the circuit breaker
should trip, determine the cause and correct the
situation.
The most likely cause of a tripped circuit breaker
would be a foreign object jamming the rail or gear
rack or overloading the elevator by exceeding its
rated load capacity.
circuit breaker with
on/off switch built in
CIRCUIT BREAKER
ELECTRICAL
To Next Page
