©2004,2002 BRUNO INDEPENDENT LIVING AIDS, INC.®
7
SRE-2700 06-11-2004
INSTALLATION
OVERVIEW OF INSTALLATION
Installation of the ELECTRA-RIDE™ LT Stairway Elevator consists of the following:
* Determine whether the elevator should be a left- or right-side installation. "Left"
or "right" installation is determined by the side of the stairway on which the rail is
installed (viewed from the bottom of the stairs). THE GEAR RACK WILL BE
TOWARD THE CENTER OF THE STAIRS. Unless specified otherwise, Bruno
Stairway Elevators are set up for left-side installation when shipped, but can easily
be converted to right-side installation. Instructions for converting the unit for
right-hand installation are included later in this manual.
* Identify and locate lower rail section and bumper bracket assembly.
* Assemble and tighten the rail joint. CAUTION: RAILS CANNOT BE MIXED.
CHECK ID NUMBERS STAMPED AT ENDS OF RAILS.
* Determine the correct length for the rail (using Steps 2 & 4 from the APPLICATION
GUIDE), and cut the rail.
* Install lower bumper assembly.
* Position rail on left or right side of stairway using rail clamp assemblies.
* Mount the carriage on the upper rail.
* Adjust the carriage angle by loosening the (2) Angle Adjustment Bolts.
* Install seat assembly and make electrical connections.
* When installing a right-side ELECTRA-RIDE™ LT , follow instructions for
Changing to Right-Hand Operation
* Perform a 5-6 trial runs of the ELECTRA-RIDE™ LT to determine final location of
the rail.
OVERVIEW
OVERVIEW
To Next Page
Loading...
