©2004,2002 BRUNO INDEPENDENT LIVING AIDS, INC.®
9
SRE-2700 06-11-2004
NOTE:
The standard stairway
elevator is suitable for
stairway angles up to
45 degrees.
• Be sure you have all necessary parts and tools before
traveling to installation site.
• Loosely assemble the foot clamp assemblies before
traveling to the installation site.
INSTALLATION
[ ] Protractor level, builder's level
[ ] Socket set, metric (10 mm through 22 mm)
[ ] Ratchet, with 6" extension
[ ] Combination wrench set, metric (10 mm through 22 mm)
[ ] Phillips screwdrivers
[ ] 5/16" socket (clamp screws)
[ ] 9/16" and 5/8" open-end wrench (limit switch adjustment)
[ ] 5/16" open-end wrench
[ ] Electric drill with letter `O' (.316") and 1/4" bit
[ ] Hacksaw with 2 or 3 blades, or metal cutting bandsaw
[ ] 20' tape measure
[ ] Small dead blow hammer
[ ] Rubber mallet
[ ] C-clamp
[ ] Wire crimper and stripper
[ ] Flashlight
[ ] Needle nose pliers
[ ] Scissors or knife
[ ] Extension cord
[ ] Double-sided foam tape
[ ] File
[ ] 12" adjustable wrench
INSTALLATION
Tools Necessary for Installation
TIPS FOR A FASTER, SMOOTHER INSTALLATION:
[ ] 90-degree needle-nose pliers
To Next Page
