EasyManua.ls Logo

Bryant 615AHA - Care and Maintenance; Manual Operation (Without Remote)

Bryant 615AHA
18 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
615AHAQ: Owner’s Manual
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
13
Fig. 12 — Louver Positions
Manual Operation (Without Remote)
To Manually Operate the Unit
1. Open the front panel of the indoor unit.
2. Locate MANUAL CONTROL on the right-hand side of the unit.
3. Press MANUAL CONTROL one time to activate FORCED
AUTO mode.
4. Press MANUAL CONTROL again to activate FORCED
COOLING mode.
5. Press MANUAL CONTROL a third time to turn the unit off.
6. Close the front panel.
Fig. 13 — Manual Control
CARE AND MAINTENANCE
Cleaning Your Indoor Unit, Air Filter
1. The air filter is on the top of the air conditioner. Hold both side of the
top filter in the place marked “PULL”, then pull it upwards.
Fig. 14 — Pull
Heating
Capacity
Test
Do not place your fingers in or near the blower and suction side of
the unit. The high-speed fan inside the unit may cause injury.
CAUTION
The manual button is intended for testing purposes and emergency
operation only. Do not use this function unless the remote control
is lost and it is absolutely necessary. To restore regular operation,
use the remote control to activate the unit. Unit must be turned off
before manual operation.
CAUTION
Manual control
button
The cooling efficiency of your unit and your health would be
damaged for the clogged AC. Make sure to clean the filter every
two weeks.
Always turn off your AC system and disconnect its power supply
before cleaning or maintaining.
Do not touch the air freshening (Plasma) filter for at least 10
minutes after turning off the unit.
Only use a soft, dry cloth to wipe the unit clean. You can use a
cloth soaked in warm water to wipe it clean if the unit is especially
dirty.
Do not use chemicals or chemically treated cloths to clean the unit
Do not use benzene, paint thinner, polishing powder or other
solvents to clean the unit. They can cause the plastic surface to
crack or deform.
Do not use water hotter than 104°F(40°C) to clean the front panel.
This can cause the panel to deform or become discolored.
CAUTION
Hold both side of the top
filter in the place marked
with “PULL”, pull it upwards
PULL

Related product manuals