2
INTRODUCTION
Bryant’s 7--day, 5/2--day, 1--day programmable and non--programmable Preferred
Series Thermidistat Control is a wall--mounted, low--voltage control which
combines temperature and humidity control in either a single unit or a two--piece
unit. In two--piece configuration, the relays are located near the equipment and a
two--wire connection is used between the Display Module and the Equipment
Control Module. Single--piece installation requires more wiring and results in a
higher profile. The Preferred Series Thermidistat has no need for batteries to store
user--configured settings in memory. During power loss its internal memory saves
settings for unlimited time, and the clock continues to run for at least 24 hours. An
extension of Bryant’s proven line of thermostats; it provides separate setpoints for
heating and cooling in addition to humidification and dehumidification.
In the programmable configuration of the Preferred Series Thermidistat Control,
different heating and cooling setpoints and times are programmable for 4 periods
per day or 2 periods per day. Programming can be done for 7 days per week, 5/2
days per week, or 1 day. The programmable Thermidistat Control can also be user
configured as a non--programmable Thermidistat Control. When operating as
non--programmable, the Thermidistat Control will still have both temperature and
humidity control.
The non--programmable Thermidistat Control features Touch ’N’ Got settings for
quick and easy temperature change without complicated programming schedules.
The non--programmable Thermidistat Control will still have both temperature and
humidity control. And, its Touch ’N’ Go technology enables the user to switch
between three different user--configurable settings through intuitive buttons located
just below the display.
To Next Page
Loading...
Need help?
General
