40
Final Settings
Be sure to press DONE to ex it installer setup mode. If the sy stem is to be left in
operation after installation is complete, use MODE button to select between HEAT,
COOL, or AUTO to provide desired operation of heating, cooling, or auto.
On the programmable models, the default setpoints and programmed schedule
conform to the Energy Starr requirements of the U.S. Department of Energy for
both heating and cooling. These provide energy saving temperature settings. Refer
to Table 1.
Table 1 – Energy Star Default Schedule
SCHEDULE
HEAT COOL
Wake 6:00 AM
68_F/20_C 78_F/26_C
Day 8:00 AM
60_F/16_C 85_F/29_C
Evening 5:00 PM
68_F/20_C 78_F/26_C
Sleep 10:00 PM
60_F/16_C 82_F/28_C
If the programmed schedule is to be used, make sure the triangle icon next to the
FOLLOW SCHEDULE icon is turned on. Pressing the Schedule button will cycle
the triangle icon through the FOLLOW SCHEDULE, HOLD and VACATION
selections.
If fixed temperatu res are desired , use SCHEDULE button to turn on arrow icon next
to HOLD. This will maintain setpoints, not allowing them to change with
programmed schedule.
The FAN button may be used to select between AUTO (fan on only with
equipment) and On (fan on continuously) fan modes. For further information on
temperature selection and programming, refer to Homeowner ’s Guide.
To Next Page
Loading...
Need help?
General
