6
INSTALLATION
UNIT DAMAGE HAZARD
Failure to follow the recommended wiring practices could result in
damage to the wall control and personal property.
Improper wiring or installation may damage AC/HP Control. Check
to make sure wiring is correct before proceeding with installation or
turning on power.
CAUTION
!
Installation Notes:
S No part of the control should be installed directly outdoors or in a cabin-
et outdoors.
S Never remove the thermostat board from the plastic housing. Doing so
could warp and damage the components on the board.
S The control assembly should be mounted before wires are attached.
S During thermostat installation, provide sufficient excess wiring behind
the mounting plate. Coil the wiring, creating a service loop, and place in
mounting box or behind the wall to remove strain against the terminal
strip. See Fig. 2.
To Next Page
Loading...
