3
INTRODUCTION
Bryant’s 7−day, 5/2−day, 1−day programmable and non−programmable
Preferred Series Thermidistat Control is a wall−mounted, low−voltage control
which combines temperature and humidity control in either a single unit or a
two−piece unit. In two−piece configuration, the relays are located near the
equipment and a two−wire connection is used between the Display Module and
the Equipment Control Module. Single−piece installation requires more wiring
and results in a higher profile. The Preferred Series Thermidistat has no need for
batteries to store user−configured settings in memory. During power loss its
internal memory saves settings for unlimited time, and the clock continues to run
for at least 24 hours. An extension of Bryant’s proven line of thermostats; it
provides separate setpoints for heating and cooling in addition to humidification
and dehumidification.
In the programmable configuration of the Preferred Series Thermidistat Control,
different heating and cooling setpoints and times are programmable for 4 periods
per day or 2 periods per day. Programming can be done for 7 days per week, 5/2
days per week, or 1 day. The programmable Thermidistat Control can also be
user configured as a non−programmable Thermidistat Control. When operating
as non−programmable, the Thermidistat Control will still have both temperature
and humidity control.
The non−programmable Thermidistat Control features Touch ’N’ Go settings
for quick and easy temperature change without complicated programming
schedules. The non−programmable Thermidistat Control will still have both
temperature and humidity control. And, its Touch ’N’ Go technology enables the
user to switch between three different user−configurable settings through
intuitive buttons located just below the display.
To Next Page
Loading...
