9
A07753
Fig. 3 − T6−NRH−A Carton Contents
1. Display Module
2. Stand−off for Equipment Control Module
3. Outside Air Temperature Sensor, screws and pigtail.
4. Equipment Control Module
Thermidistat Control Location
Thermidistat Control should be mounted:
Approximately 5 ft (1.5m) from floor.
Close to or in a frequently used room, preferably on an inside parti-
tioning wall.
On a section of wall without pipes or duct work.
Thermidistat Control should NOT be mounted:
Close to a window, on an outside wall, or next to a door leading to the
outside.
To Next Page
Loading...
