13
PROCEDURE TO TEST TRIGLYCERIDES
3.b.2. Sit down for one minute with the arm along the body. Massage the finger to
be pricked to increase the blood flow. After inserting the strip, the code of the
data-chip and the blinking drop will appear on the display, indicating that the
meter is ready to receive the blood. Perform the finger pricking by using the
lancing device and a sterile lancet. Remove the first drop with a sterile gauze
and gently press the finger to obtain the second drop. Apply the blood on the
white circular area of the strip coming out from the meter. Wait until moving
segments will appear on the display and until to hear an acoustic signal
(“beep”).
4. Wait for the result, which will be displayed and stored in the memory of the device
automatically (refer to the instructions for use of the strips that you are using to
know the reading time).
5. Use the ejector on the back side of the device to remove the used strip, pointing
the device down.
To Next Page
Loading...
