14
If you get results which do not correspond to your feelings, run a check of the MULTICAREIN device and
contact your physician. If you get extreme results, too high (Hi) or too low (Lo), contact your physician
immediately.
When the measurement is finished, it is possible to switch o the MULTICAREIN device. The device will
switch o automatically after 60 seconds if it is not used for other operations.
The last measured value, along with date and time, will be saved in position 1 in the memory of the
device. The values previously measured will be saved in position 2, 3 etc. starting from the most recent.
How to recall from the memory a measured value and how to erase memorized values is described on
page 17.
The used strips and materials have to be properly disposed, avoiding contamination. The device has to be
disposed following the electric and electronic waste law.
In laboratories and hospitals, the procedures of biological safety must be
followed when handling potentially infected material, in particular when
measurements are performed on dierent patients.
To avoid infections, clean the device regularly and dispose of the used
strips in a way that there is no risk of infections for other people.
WARNINGS
To Next Page
Loading...
