Bside ADM02 - DC;AC μA or mA Measurement; DC;AC 10 A Measurement

④ Press the ‡ FUNC· key to enter to the continuity mode.
⑤ The buzzer sound if the resistance of a circuit under
test is less than 100έ .
5-4. DC/AC µA or mA measurement
DC Current range is 200.0¸ A/2000¸ A and
20.00mA,/200.0mA and then 10A range.
AC Current range is 200.0¸ A/2000¸ A and
20.00mA,/200.0mA and then 10A range.
④ Turn off power to the circuit. Set the rotary switch
to the proper DC/AC ¸ A or DC/AC mA position.
⑤ Break the current path to be tested. Connect the
red test lead to the more positive side of the break
and the black test lead to the more negative side of
the break.
⑥ Turn on power to the circuit. The measured value
show on the display.
5-5. DC/AC 10A measurement
④ Insert the red test lead into the input terminal
marked as ‡ 10A· .
⑤ The measuring procedure is same as that of 5-4
section..
Note:
◤ For safety”s sake, the measuring time for high current
should be ≧ 10 second for each measurement and the
interval time between two measurement should be
greater than 5 minutes.
◤ When current measurement has been completed,
disconnect the connection between the testing lead and
the circuit under test.
5-6. Temperature measurement
To measuring temperature should be use the K-type
11