Handling guide
03 SAFE HANDLING GUIDE
3.1 TOOLS
The following tools are required to install the battery pack:
• Cross screwdriver.
• Wire cutter.
• RJ45 crimping plier.
• Hydraulic cable plier.
• Multimeter.
Note:
1) Use properly insulated tools to prevent accidental electric shock or short circuits.
2) If insulated tools are not available, cover the entire exposed metal surfaces of the availa-
ble tools, except their tips, with electrical tape.
3.2 GEARS
It is recommended to wear the following safety gear when dealing with the bat-
tery pack:
• Insulated gloves
• Safety goggles
• Safety shoes
3.3 Location
Make sure that the installation location meets the following conditions:
• The installation site must be suitable for the size and weight of the battery.
• The battery must be installed on a firm surface to sustain the weight.
• The area is dry and ventilated.
• There are no inflammables and explosives nearby.
• The ambient temperature is within the range from 0°C to 50°C.
• There is minimal dust and dirt in the area.
Note:
If the ambient temperature is outside the operating range, the battery pack stops operating
to protect itself. Frequent exposure to harsh temperatures may deteriorate the performance
and life of the battery pack.
07
To Next Page
Loading...
Need help?
General
