16
Do not press the button
when the Baby unit and
Parent unit are positioned in
the same room. High-pitch
noise will be generated if the
button is pressed when the
Baby unit and Parent unit are
close to each other or within
3 metres distance.
When using Talk back, hold
the Parent unit approximately
30cm in front of your mouth
when talking to baby.
1. Press and hold down the button on the Parent
unit to speak to your baby.
Whilst the
button is depressed the green Link
indicators will flash on both units.
Parent unit battery LED indicator (top of unit)
When the Parent unit is on charge, the battery LED
will be solid red. When the power is removed, the
LED will switch off. When the battery is low, the LED
will flash.
Find
You can press the button on the Baby unit to
make the Parent unit sound an alert beep to help
you find it if it’s been misplaced. If the Parent unit
loudspeaker volume had been muted (or set to
volume off), the volume level will be reset to the
default setting of Level 3.
1. Press
on the Baby unit. The paging alert will
sound at the Parent unit.
2. To stop the alert, press any button on the Parent
unit or press the
button again on the Baby unit.
If no button is pressed after 2 minutes then the
alert will automatically stop.
2250 Baby Monitor 300 UG Iss2.[2].indd 16 10/04/2014 11:06
To Next Page
Loading...
