20
• Check units are within range of
one another.
• Check both units are turned on.
Link indicator is flashing red
• The Link between your units is
broken. You will also hear an alert
on the Parent unit to let you know
there is no communication between
the units. If this happens, check
that the mains power (or batteries)
is correctly connected and that
the units are within range of one
another. See page 10 for instructions
on linking the units.
Battery low on Parent unit
• Put the Parent unit back on charge.
• Place the Parent unit back on charge
as frequently as possible or ideally
leave it on charge to ensure the
batteries remain charged.
• To fully charge the batteries, the
Parent unit should be on charge for
approximately 24 hours if switched
on or 16 hours if switched off to
reach maximum charge.
• To speed up the charging process
turn the Parent unit off when
charging if it is not being used.
Parent unit remains silent or
very quiet
• You may have set the volume
too low, see page 14 to increase
the volume.
You can hear a high pitched noise
• The units might be too close to
each other.
• The volume setting might be too
high, see page 14.
Talk back feature is not working
• Check that the units are linked.
2250 Baby Monitor 300 UG Iss2.[2].indd 20 10/04/2014 11:06
To Next Page
Loading...
