If you experience any problems, please visit www.bt.com/producthelp
10
10
Each number can be up to 32 digits long and can
include a pause or #.
If you enter more than 32 digits you will hear an
error beep.
You can store your 3 most frequently used phone numbers on the one-touch memory
buttons (
, and ) and dial them by pressing a single button.
Store/replace a one touch number
1. Lift the handset, or press
, to get a line.
2. Press and hold the
, or button you want until you hear a
beep and the Secrecy light ashes.
3. Enter the number you want to store.
4. Press the same
, or button to conrm. The number is
stored. You hear a conrmation beep.
Dial a one-touch memory number
1. Lift the handset, or press
, then press the one-touch button you want.
The stored number is dialled.
Storing a pause in a number
A pause is normally inserted in a stored telephone number after a switchboard
access code (e.g. 9) to allow the switchboard time to get an outside line before
the number is dialled. For example,
9 – Pause – 08702405522.
1. To enter a pause, press
in the appropriate place when storing the number.
Delete a stored number
1. Lift the handset, or press
, to get a line.
2. Press and hold the
, or button you want until you hear a
conrmation beep and the Secrecy light ashes.
3. Press
to delete the stored number. You hear a conrmation beep.
4. Replace the handset or press
.
M1 – M3 memory buttons
To enter a pause when storing a number
press
.
To cancel while storing, hang up the handset
or press
. Any number already stored
will be kept.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
