If you experience any problems, please visit www.bt.com/producthelp
6
Handset park
If the phone is wall-mounted,
you can hang the handset
here if you need to leave the
phone during a call.
M1 one-touch
memory button
Store your most important
one touch number here,
page 10.
Redial
Redials the last number called,
page 7. Use to enter a pause.
Headset socket
(underneath the phone)
Lets you connect a Headset
(not supplied), page 7.
Handsfree button and indicator
Make and receive calls
handsfree. Indicator light is
on when in use, page 8.
Headset button and indicator
Make and receive calls with a
headset. Indicator light is on
when in use.
R (Recall)
For use with a switchboard
and some BT Calling Features,
page 9.
Volume –/+
Adjust earpiece, headset or
speaker volume during a call.
Getting to know your phone
Message waiting indicator
Flashes if you have
Voicemail, page 8.*
Call indicator
Flashes when you have
an incoming call.
One touch memory label
Keep a note of your
numbers.
Dialling mode switch
(underneath the phone)
Lets you set the dialling
mode, page 16.
Message waiting switch
(underneath the phone)
See page 8 for details if
you are connected to a
switchboard.
Ringer switch
(underneath the phone)
Lets you adjust the ringer
tone, page 9.
Ringer volume switch
(underneath the phone)
Lets you adjust the ringer
volume, page 9.
Secrecy button and indicator
During a call, press to stop
your caller hearing you
so you can talk privately
to someone else close by,
page 7. Indicator light is on
when in use.
Amplify
Press to switch the
earpiece/headset volume
to High, page 9.
Buttons and features
M2-M11 on-touch buttons
Store and dial one-touch numbers.
Bottom 5 buttons are pre-programmed
with BT Services numbers, page 10.
* The light will only ash if your BT Converse is connected to a PBX switch or similar.
The light will not ash when used with network services such as BT 1571.
To Next Page
Loading...
