8
If you experience any problems, please visit www.bt.com/producthelp
Using the phone
Handsfree
Make and receive calls without lifting the handset.
Making a handsfree call
1. Press
. You will hear the dial tone.
2. Dial the number you want. When your call is answered, speak as normal
(or if you wish to speak to your caller privately, pick up the handset).
3. Press
to end the call.
Receiving a call handsfree
1. When the phone rings, press
and speak. Press to end the call.
Message waiting
If your BT Converse phone is connected to a switchboard, the message waiting
indicator will ash when you receive new voicemail messages.
BT 1571 or similar network voicemail users can also use this feature, however
the indicator light will not ash. New voicemail messages will be indicated by a
stuttered dial tone when you pick up the handset.
Message waiting switch
If your telephone is connected to a switchboard you may need to change the
message waiting switch setting on the base of the phone. It is pre-set to MW3
which is for an SX2000 switch. MW1 and MW2 positions are for when the
telephone is connected to an ISDX switch. If the switch is moved to MW2 and the
message waiting indicator stays on permanently, use MW1.
To Next Page
Loading...
Need help?
General
