21
If you experience any problems, please visit www.bt.com/producthelp
The default setting is Answer &
Record.
Answer & Record
The pre-recorded Answer & Record
outgoing message, that allows
your caller to leave a message, is:
“Hello, your call cannot be taken at
the moment, so please leave your
message after the tone”.
Answer Only
The pre-recorded Answer Only
outgoing message where the caller
hears an announcement but cannot
leave a message, is: “Hello, your call
cannot be taken at the moment, so
please call later”.
Using the answering
machine
Your BT Decor 2500 can digitally record up to 30 minutes of
messages. It comes with two pre-recorded outgoing messages,
Answer & Record or Answer Only, alternatively you can record
your own version of each.
When first plugged in, your BT Decor 2500 answering machine is
ready to go. It is set to answer calls and record messages. If you
have not already set the time and date, you will need to do this so
that you will know when each message was received, see page 6.
Switch the answering machine on/off
1. Press the button to switch between Answer On and
Answer Off. The selected setting will be announced.
Set the answer mode
There are 2 answer modes to choose from: Answer & Record and
Answer Only. When set to Answer & Record, your caller will hear
the outgoing message and be invited to leave a message. When
set to Answer Only, the caller will hear the outgoing message but
will not be allowed to leave a message.
1. Press the
button. Answer Machine will be displayed,
press
.
2.
Answer Mode will be displayed, press .
3. The current mode will be displayed. Use the
or
buttons to scroll to the setting you want, either
Answer &
Record or Answer Only and press .
Outgoing messages
The outgoing message is the message a caller first hears when the
answering machine picks up their call. There are 2 pre-recorded
outgoing messages to choose from (see note right), or you can
record your own.
To Next Page
Loading...
