BT Decor 2500 - Record Your Own Outgoing Message; Play;Check Your Outgoing Message; Reinstate the Pre-Recorded Outgoing Message

22
If you experience any problems, please visit www.bt.com/producthelp
The display will show OGM Recording
while you record your own outgoing
message.
Record your own outgoing message
Your own outgoing message can be up to 2 minutes long. It will
replace the pre-recorded outgoing message. You can re-instate
the pre-recorded message if you want to, see below.
1. Press the
button. Answer Machine will be displayed,
press
.
2.
Answer Mode will be displayed, press to scroll to
Outgoing Message and press .
3. Scroll
to display Record OGM and press and hold
down the
button.
4. After the beep, speak your message clearly into the
microphone on the base (located on the bottom right of base).
5. To end recording, release the
button. Your message will be
played back to you.
Play/check your outgoing message
1. Press the button. Answer Machine will be displayed,
press
.
2.
Answer Mode will be displayed, press to scroll to
Outgoing Message and press .
3.
Play OGM will be displayed, press . Your outgoing message
will be played.
Reinstate the pre-recorded outgoing message
This will delete the outgoing message you recorded and the pre-
recorded outgoing message will be re-instated.
1. Press the
button. Answer Machine will be displayed,
press
.
2.
Answer Mode will be displayed, press to scroll to
Outgoing Message and press .
3.
Play OGM will be displayed, press . Your outgoing message
will start playing, press
to delete it. The pre-recorded
message will be played.