BT REFLEX RR B - 13.5.2 Leakage from the upper cover; 13.5.3 Leakage from the lower cover

Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 13- 11
Mechanical drive gear unit – 2550
Repairs
13.5.2 Leakage from the upper cover
Follow instructions below in the event of leakage from the transmis-
sion's upper cowl:
• Remove the transmission from the truck as described in the section
"Replacing the drive motor/drive transmission"
• Loosen all bolts holding the upper cowl on the transmission housing.
• Remove the cover from the transmission housing and clean the
sealant surfaces carefully, both on the cowl and the transmission
housing.
• Apply sealant such as Curil K2 to the surfaces. Follow the instruc-
tions on the package.
• Fit the cover and tighten the bolts to a torque of 46 Nm.
The bolts should be greased prior to assembly.
• Fill with oil as set out in the instructions for refilling.
• Assemble the drive transmission/drive motor and fit the drive as-
sembly in the truck as described in the section "Replacing the drive
motor/drive transmission."
13.5.3 Leakage from the lower cover
• Drain the remaining oil from the transmission.
• Dismantle the cover from the transmission.
• Replace the sealing ring on the drainage plug and the O-ring on the
cover.
• Mount the cover and tighten the bolts to a torque of 25 Nm. Make
sure the O-ring is not damaged. The bolts should be greased before
assembly.
https://www.forkliftpdfmanuals.com/