Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B,E RR B,E CC 9- 1
Driver protection – 0840
General
9- Driver protection – 0840
9.1 General
To increase the truck’s capacity, tilt stops are fitted to some trucks. Tilt
stops are also available as an option
on other trucks.
It is, however, permissible to temporarily remove tilt stops during trans-
port of the truck, for instance, between different warehouses, but the
truck may not then be used to transport loads.
WARNING !
Reduced stability.
Trucks without tilt stops can tip over, if used to transport loads.
Ensure that tilt stops are refitted with proper distance to the floor if
they have been temporarily removed.
The tilt stops are located on the rear corners of each support arm and
consist of lugs, shims, bolts and washers.
.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...