BT RRE180 - Assembling the Pump Motor

9 – 6 Repair Manual RRE140/160/180/200/250 © BT
Motors 1000
Pump motor (1710)
T-code Valid from serial number Date Publication No.
815, 816 6051502 2008-08-21 261828-040
Assembling the pump motor
Ensure all parts are intact and clean before assembly.
1. Place a bearing (q) in the D-shield (a).
2. Place the support ring (p) and locking ring (o) in the D-shield (a).
3. Place the stator (b) in the D-shield in line with the markings made
during dismantling.
4. Push the bearing (s) onto the rotor shaft.
5. Place the rotor in the D-shield.
6. Place the locking ring (m) on the rotor shaft.
7. Place the seal (n) using the assembly device.
IMPORTANT
Always use a new seal when fitting the rotor shaft.
8. Place the spring washer (j) and N-shield (e).
9. Secure the four screws (g) that hold the power terminal block (h) in
the N-shield.
10. Place the four long screws (c) - tightening torque 15 Nm.
11. Place the pulse transducer (d) in the N-shield and attach the cable
clamp (f).
12. Attach the pulse transducer's connector unit in the bracket under
the power terminal block.
q
p
o
e
j
a
b
c
d
e
f
g
h