2322
Sfera Keypad Module
User and installation manual
6
7
5
6. Enter the code again to confirm. The device emits a long confirmation beep.
7. If the procedure is successful, the green LED stays on for approximately 1 second and then
switches off.
During the programming procedure, it will be necessary to follow some rules:
- keys must be pressed in succession (with maximum 2 seconds in between pressures).
- the programming sequence must start within 30 seconds from the pressure of the
programming button, and must be completed in one stage.
5. Press the
key
A short sound confirms the programming of the new passepartout code.
To Next Page
Loading...
Need help?
General
