24
Sfera Keypad Module
User and installation manual
4
3
Apartment 1
Apartment 2
Apartment 3
Apartment 4
2
3. Press the key
4. Enter the resident code (4 to 9 digits).
1. Enter the administrator code.
The device emits a confirmation beep and the green LED flashes The programming stage has
started.
2. Using the pushbutton module (352000 and 352100), select the apartment to which to associate
the resident code.
Resident code
To access the programming of a “RESIDENT” code, it will be necessary to have an administrator
code It is possible to store up to 4000 codes, one for each apartment.
The keypad module will indicate if the code is accepted or rejected through audible signals and
the switching on of the green LED. Entering an unrecognised code will cause the interruption of
the programming procedure. This interruption will be notified with an extended beep and the
switching on of the red LED.
Note : only with Sfera Speaker Module 351100/351200/351300 + the associated Sfera Pushbutton
Modules 352000/352100.
New resident code
To Next Page
Loading...
