EasyManua.ls Logo

Bticino AXOLUTE - User Manual

Bticino AXOLUTE
2 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
PART. T2420E
NO
NO
BIIIP !!
B
I
I
I
I
P
!
!
Premere solo una volta
Nur einmal drücken
Appuyer une seule fois
Press once only
Pulsar sólo una vez
Slechts één keer indrukken
NO
NO BIIIP !!
OK
B
t
i
c
i
n
o
5 cm
~ 15 sec
Istruzioni d’uso
Gebrauchsanweisungen
Notice d’emploi
Instructions for use
Instrucciones de uso
Gebruiksaanwijzing
08/05-01 PC
MAX 5
Se il rilevatore non va in allarme
Wenn der Detektor nicht auf Alarm schaltet
Si le détecteur ne se met pas en alarme
If there is not an alarm on the detector
Si el detector no señaliza una alarma
Indien de detector niet in alarm gaat
Il ripetitore di segnale e l’elettrovalvola
vengono attivati circa 1 minuto dopo la
segnalazione dell’allarme da parte del
rilevatore.
Der Signalmelder und das Magnetventil
werden etwa 1 Minute nach der
Alarmmeldung durch das Meldegerät
eingeschaltet.
Le répétiteur de signal et l’électrovanne
sont activés environ 1 minute après la
signalisation de l’alarme par le détecteur.
The signal repeater and the solenoid valve
are activated about 1 minute after the
detector gives the alarm signal.
El repetidor de señal y la electroválvula
se activan cada aproximadamente 1 minuto
después de la señalización de la alarma
por parte del detector.
De relaiszender van signaal en de
elektroklep worden geactiveerd ongeveer
1 minuut na de signalering van het alarm
vanwege de detector.
00
15
45
30
00
15
45
30

Other manuals for Bticino AXOLUTE

Questions and Answers

  • C
    Crystal WilsonJul 28, 2025
    Why does my Bticino AXOLUTE handset not ring when called?
    • R
      Robert BerryJul 28, 2025
      If your Bticino Intercom System handset isn't ringing when called, there are a couple of things to check. First, ensure that the handset and entrance panel are correctly wired and configured. Also, verify that the "Call Exclusion" function is not active, and the bell volume hasn't been set to zero.
  • K
    kburgessAug 3, 2025
    What to do if pressing the Entrance panel Activation/Cycling key on my Bticino AXOLUTE Intercom System shows no picture?
    • A
      Anna FloresAug 3, 2025
      If pressing the Entrance panel Activation/Cycling key on your Bticino Intercom System doesn't display a picture, verify that the handset and entrance panel are correctly wired and configured, ensuring they share the same P address. Another possibility is that the audio/video channel is currently in use; wait for it to become available and then try again.
  • M
    Matthew GibbsAug 9, 2025
    Why is it difficult to hear the caller at the Bticino Intercom System handset?
    • N
      Natalie RichardsonAug 9, 2025
      If you're having trouble hearing the caller at the Bticino Intercom System handset, check the volume setting on the Axolute Video Station. Also, make sure there aren't any strong noise sources nearby. You can also communicate in PUSH TO TALK mode.
  • A
    Anita ThompsonAug 14, 2025
    What to do if pressing the OK key on my Bticino AXOLUTE Intercom System doesn't switch on the menu and makes a busy sound?
    • E
      Edwin TannerAug 15, 2025
      If pressing the OK key on your Bticino Intercom System results in a busy sound and the menu doesn't appear, it's likely that the audio/video channel is currently busy. Please wait for it to become free and try again.
  • C
    Chase CalderonAug 21, 2025
    What to do if pressing the Door lock key on my Bticino AXOLUTE doesn't perform the command?
    • K
      kristy32Aug 21, 2025
      If pressing the Door lock key on your Bticino Intercom System doesn't activate the door lock, check that the handset and entrance panel are correctly wired and configured, ensuring they share the same P address.

Summary

Bticino Detector Operation

Single Press Button Function

Instruction to press the device button only once for activation.

Alarm State Indicators

Visual and audible indicators for alarm states (OK BIIIP!!, NO BIIIP!!).

Delayed System Activation

Signal repeater and solenoid valve activate 1 minute after the detector alarm.

Safety Precautions

Fire and Heat Hazards

Warning against exposure to fire, sun, and temperatures exceeding 50°C.

Ignition Source Prohibition

Do not use near smoking, open flames, or other ignition sources.

Bticino AXOLUTE Specifications

General IconGeneral
Wiring2-wire
Night VisionYes
Hands-freeYes
DisplayLCD
CameraColor

Related product manuals