Operation2
42
To learn more, press the
key
The display provides the following information:
- detector and its name (living room window)
- type of alarm (intrusion)
- burglar-alarm (antitheft) status when the
alarm goes on (ON-inserted)
The alarm signal is cancelled from the display
the next time you turn on the burglar alarm
(antitheft), but it remains memorised in the “Event
memory”, which can be consulted by selecting
“Event memory” in the Burglar-alarm (antitheft)
menu.
The Unit has detected an alarm
...
What type of alarm occurred? ■
When an alarm signal is displayed, you can nd out what type it is (intru-
sion, technical, etc.) and which detector has detected it; a name has been
given to each detector (kitchen window, entrance, etc.) by the installer for
easier identi cation. Press just one key to get this information.
To learn more, press the
key
The display provides the following information:
- device name (remote assistance)
- type of alarm (technical start)
- burglar-alarm (antitheft) status when the
alarm goes on (OFF-disconnected)
The Unit has detected a technical alarm
By pressing the
key, a page appears, which
lets you reset a single alarm or execute a total
reset
In case of a technical alarm (its symbol appears), you can nd out which
device has produced the alarm and reset it as well.
1 2 3 4
1
2
ABC
3
DEF
MNO
6
JKL
5
GHI
4
7
PQRS
8
TUV
9
WXYZ
0
/
MEMO ALARMS
32 : IR sensor
Living Room Window
Intrusion alarm
inserted
1 2 3 4
ATTYENZIONE
press:
OK reset single
OK reset total
MEMO ALARMS
42: receiver
remote assistance
start technical
Disconnected
To Next Page
Loading...
Need help?
General
