Editing 3
49
Code/key
*
ANTITHEFT
Date and hour
Commands
Automations
Settings
Accessing the edit menu
Select Settings with the
keys and then press
Changing the user code ■
The Burglar-alarm Unit is protected by two codes which originally are
identical (00000).
The maintenance code (for installation technician use only) allows access
to all configuration menus of the unit; however, for safety reasons, this
code does not enable / disable the burglar alarm but, if the burglar
alarm is enabled it will not allow access to the menus.
The user code enables / disables the burglar alarm as well as the access
to the configuration menus (except those for the installation techni-
cian). The user code cannot be modified if the installer code has not
been modified.
The basic user code is: 00000 and it is the same for all manufactured
units. It is therefore recommended to change it with another one of
your choice in order to give your system the highest safety. The proce-
dure for changing the user code is as follows:
The page on the right appears; the
cursor is already positioned on the
rst digit of the new code
Type in the new code you have
chosen. The new code must have 5
digits (e.g. 67890)
Select User code with the
keys and then press
Enter the new code with
next
SETTINGS
Entry delay
Exit delay
User code
Select
SETTINGS
Entry delay
Exit delay
User code
Select
User code
Present: 12345
New: 00000
User code
Present: 12345
New: 67890
To Next Page
Loading...
Need help?
General
