Btwin Original 7E - Recharging the Battery and Indicators

17
The electrically-assisted bike has a lithium-ion battery which powers the motor.
Unlike other batteries, it is "memory free".
It can therefore be charged whatever its status may be.
When it is used for the rst time, charge it up fully (100%)
RECHARGINGTHEBATTERY
1. Remove the protective cover on the charging connector located on the side
of the battery.
2. Insert the charger plug into a power socket. The charger LED will light up
green.
3. Then connect the charger to the battery by inserting the charger connector
into its socket on the battery.
4. At the start of charging, the charger LED will go to orange and the LED's on
the battery will light up (according to the status of your battery).
5. During charging, the charger LED will remain orange and the battery LED's
will light up as charging progresses (see the charging indication table
below).
6. Once charging is complete, it will stop automatically. The charger LED will
switch to green and the LED's on the battery will go out 10 minutes after the
battery is fully charged (charging lasts approximately 6 hours).
7. You can then disconnect the battery from its charger and use it.