Bubble CORNER - Rules and Regulations; CO Alarms

4
Identification.
A serial number plate is fastened to the appliance and printed on the warranty document
displaying information about the product.
When ordering consumables and spare parts it will be necessary to quote the serial number.
Consequential loss.
The manufacturer will not be responsible for any consequential or incidental loss or injury
however caused.
R
R
U
U
L
L
E
E
S
S
A
A
N
N
D
D
R
R
E
E
G
G
U
U
L
L
A
A
T
T
I
I
O
O
N
N
S
S
.
.
When fitting a new or replacement, wood or solid fuel heating appliance, you are required
by law to obtain Building Control Approval from your local authority OR the work must be
carried out through a government approved, competent persons scheme such as that
operated by HETAS who can be contacted on 0845 634 5626
www.hetas.co.uk .
In addition to these instructions the requirements of BS 8303 and BS EN 15287-1:2007
must be fulfilled.
A faulty installation can cause life threatening danger to the property and its occupants
therefore it is very important to understand the requirements of the national Building
Regulations and standards, along with any local regulations and g o o d working practices
that may
apply.
Should any differences between these instructions
and the Building Regulations then
the B ui l di ng R egulations must
apply.
Your local Building Control Office can advise regarding the
requirements of the
regulations.
C
C
O
O
A
A
L
L
A
A
R
R
M
M
S
S
.
.
The following alarm must be fitted in the same room as the appliance.
Carbon Monoxide Alarm to BS EN50291:2002
It is also advisable to fit an Optical Smoke Alarm to BS EN14604