Buchi Rotavapor R-220 - Support Rod Setup

8
2OTAVAPOR R-220
0UTTINGINTO/PERATION
&IG3UPPORTROD
4.3 Setting up the Support Rod
s 0LACETHESUPPORTROD햳INTOTHEHOLDERPROVIDEDFORITAND
LOWERITINTOTHEFOOTHOLEATTHEBACK&IXITTIGHTUSINGTHE
LOCKINGSCREW햲
s 0UTTHEPOSITIONINGRING햴ONOVERTHERODMMBELOW
THEUPPEREDGE
s ,AYTHEPIVOTINGCLAMP햵ONTOPOFTHEPOSITIONINGRING
s !TTACHTHEPIVOTINGCLAMPFORTHERECEIVINGFLASKMM
ABOVETHEBOTTOMEDGEOFTHEROD
7HENINSTALLINGANINTERCHANGEABLERECEIVER
s 0LACETHESHORTSUPPORTRODINTOTHEHOLDERATTHEFRONTAND
LOWERITINTOTHEFOOTHOLE3CREWITTIGHTUSINGTHELOCKING
SCREW
s !TTACHTHEPIVOTINGCLAMPAPPROXMMABOVETHELOWER
EDGEOFTHEROD
햲
햴
햳
햵