Need help?Do you have a question about the Buchi Rotavapor R-100 and is the answer not in the manual?
General| Type | Rotary evaporator |
|---|---|
| Rotation Speed | 20 - 280 rpm |
| Heating Bath | HB Digital (optional) |
| Temperature Range | Up to 180 °C |
| Power Supply | 230 V / 50 Hz |
| Bath Temperature | Up to 180°C |
| Glassware | Various glassware configurations available (e.g., A, B, C, D, E, G) |
Explains danger levels and signal words used in the manual.
Introduces warning, mandatory, and other symbols used in the manual and on the device.
Information on instruction translations and trademark usage.
Defines intended uses and lists applications that are not permissible.
Specifies user qualifications and outlines potential hazards.
Details necessary PPE and warns against unauthorized modifications.
Explains the rotary evaporation process and the R-100's general configuration.
Details front/rear views, interfaces, and typical application setup.
Illustrates system setup and explains device identification plate information.
Shows device symbols, lists supplied components.
Provides technical specifications for the unit, bath, ambient conditions, and materials.
Details safety mechanisms like overheat cut-out and overload protection.
Requirements for installation site and mounting the rotary drive unit.
Instructions for fitting vapor duct, condenser, stopcock, and tubing.
Details electrical hookups and provides an overview of system connections.
Instructions for filling the heating bath and performing a quick installation check.
Steps to prepare the heating bath, fit flasks, and adjust angles.
Step-by-step guide for carrying out the distillation process.
Guides on flask height, distillation conditions, and process optimization.
Instructions for feeding solvent and finishing distillation.
Procedures for safely removing the evaporating and receiving flasks.
Inspecting and cleaning the vapor duct and checking the system for leaks.
Checking seals and cleaning the condenser.
Cleaning the heating bath and removing solvent accumulations.
A guide to common faults, their causes, and remedies.
Instructions for resetting overheat cut-out and replacing fuses.
Procedures for safely decommissioning and disposing of the equipment.
A table listing various solvents with properties relevant to distillation.
Lists available spare parts, accessories, wear parts, and glass apparatus.
Provides lists of abbreviations and health/safety approval requirements.
To Next Page