Buchi SpeedDigester K-436 - SpeedDigester K-436 - Rear Side; Preparing SpeedDigester, Suction Module(s) and Sample Tubes

6 Operation
27 K-425 / K-436 Operation Manual, Version B
6.1.4 SpeedDigester K-436 — rear side
Bracket with magnetic
(elbow) suction plugs
T-piece with
suction hoses
Type plate
Fuse holders
Power socket
6.2 Preparing of SpeedDigester, suction module(s) and sample tubes
Section 6.2.1 and 6.2.2 describes the standard procedure for preparing a rack with sample tubes of
300 ml or 250 ml. When 500 ml tubes are being used, additionally refer to section 6.2.4.
Note
A rack may achieve a weight of up to 7.5 kg when loaded with samples and equipped with a suction
module. Be prepared for the weight when lifting a rack!
!
WARNING
Serious chemical burns by corrosives and peroxides.
• Observe supplementary data sheets of all used chemicals
• Handle corrosives and other chemicals in well ventilated environments only
• Always wear protective goggles
• Always wear protective gloves
• Always wear protective clothes
• Do not use damaged glassware
• Use only glassware from qualified vendors (see 2.5.4)