4
|
Logamatic 2107 Controls
Applications Manual
Logamatic 2107 Controls applications manual | 06.2018
Technical specifi cations are subject to change without prior notice
1 Introduction
This manual addresses some of the many applications that are
possible using Buderus outdoor reset controls. Applications
depicted in the manual are presented with both hydraulical and
electrical outlines. The drawings contained in this manual are
intended to be used as an aid to system installers and
designers and are conceptual in nature. Auxiliary equipment
depicted in this manual does not necessarily represent any one
particular manufacturer or specifi c model number. There are a
wide variety of techniques, practices and piping arrangements
possible with hydronic heating systems and it is the
responsibility of the installing contractor to determine which of
these is best suited for a specifi c application.
In an eff ort to simplify electrical drawings, they have been
limited to zone controlling only (space heating and DHW). Other
constants such as power input, boiler sensor and outdoor
sensor wiring have also been eliminated. Information for wiring
of burners can be found in section 9 of this manual. Further
information can be found in the control service manual.
Although this manual covers many common applications for our
equipment, the possibilities are virtually endless. Should you
encounter an application that is not covered in this manual or
have questions regarding any of its content, we encourage you
to contact us here at Bosch Thermotechnology Corp.
Bosch Thermotechnology Corp. reserves the right to make
changes without notice due to continuing engineering
and technological improvements .
To Next Page
Loading...
Need help?
General
