What does remote control 1 error REMOTE1 ERROR mean on my Buderus Network Router?
The remote control 1 error may be due to the remote control having the wrong address, incorrect wiring, a defective remote control, or an interrupted connecting cable. Check the address, the wiring and replace the remote control if needed.
What to do if I see 'Heating error' on my Buderus Control Systems?
If you are seeing a 'Heating error' on your Buderus Control Systems, it could be due to several reasons. First, ensure that the boiler water thermostat is set to 'AUT'. Also, check the manual reset high limit (STB). Verify the fuel supply and confirm that the sensor is correctly positioned.
What to do if my Buderus Logamatic 2107 show 'DHW PROD ERR' message?
If your Buderus Control Systems are displaying the 'DHW PROD ERR' message, try these steps: First, turn the power off to the R2107 to reset it. Then, check terminals 24 & 25 for 120V; if power is present and the boiler fires, the R2107 is okay. Also, inspect the circulator for any issues, check for stuck flow, ensure the piping isn't air bound, and verify that no valves are closed.
What does 'Boiler sensor error BLR SENSOR ERROR' mean on my Buderus Control Systems?
If your Buderus Control Systems display a 'Boiler sensor error BLR SENSOR ERROR' message, it indicates that the sensor is defective or the connecting cable is interrupted. Check the sensor connection and replace the sensor if necessary.
What does 'Outdoor sensor error OA SENSOR ERROR' mean on my Buderus Control Systems?
If your Buderus Control Systems display an 'Outdoor sensor error OA SENSOR ERROR' message, it means the sensor is defective or the connecting cable is interrupted. Check the sensor connection and replace the sensor.
What to do if there is a heating error on my Buderus Network Router?
If you encounter a heating error, ensure the boiler water thermostat is set to "AUT". Also, check if the manual reset high limit (STB) has tripped. Verify the fuel supply and the sensor position.
What does it mean when my Buderus Logamatic 2107 Control Systems displays 'FM 241 ERR FM 242 ERR FM 244 ERR'?
If your Buderus Control Systems displays 'FM 241 ERR FM 242 ERR FM 244 ERR', this indicates that the controls can no longer detect a previously detected module. Consult your local heating contractor.
What to do if my Buderus Logamatic 2107 display shows 'REMOTE 1 ERR' or 'REMOTE 2 ERR'?
If your Buderus Control Systems display shows 'REMOTE 1 ERR' or 'REMOTE 2 ERR', consult your local heating contractor.
What does 'FM 241 error (mixing card) FM 241 ERROR' mean on my Buderus Control Systems?
If your Buderus Control Systems display an 'FM 241 error (mixing card) FM 241 ERROR' message, it means the module is no longer present or is defective. Log the module off, plug the module in again, and replace the module if necessary.
What does 'Collector sensor error SL SENSOR ERROR' mean on my Buderus Logamatic 2107 Control Systems?
If your Buderus Control Systems display a 'Collector sensor error SL SENSOR ERROR' message, it means the sensor is defective, the connecting cable is interrupted, or the solar module (FM 244) is defective. Check the sensor connection, replace the sensor, and replace the module.
General| Category | Control Systems |
|---|---|
| Type | Heating Control Unit |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Protection class | IP20 |
| Ambient temperature | 0°C |
| Application | Heating systems |
To Next Page
