8.5 Remote control ON/OFF
A BFU (accessory) remote control allows to easily control a heating system from
the living space.
If the controller is equipped with a BFU remote control, the remote control must
be activated and assigned to the appropriate heating circuit.
Instructions for assigning the remote control to the required heating circuit
(HK1 or HK2) can be found in the remote control operating instructions.
The factory setting is:
Activating the remote control
Further information on this can be found on the next page.
For remote control: "OFF"
USER NOTE
Faulty communication is indicated by the LEDs flashing on the remote control.
+
Press the "Display" key and "Install" key at the same time to call up the service
level. "AMERICAN" appears as the first main menu.
Turn the dial until "HEAT CIRC 1" or "HEAT CIRC 2" is displayed.
Press "Display" to call up a submenu.
"RADIATOR" or "UND-FLOOR" appears.
Turn the dial until "REMOTE 1" for heating circuit 1 or "REMOTE 2" for heating
circuit 2 is displayed.
+
Hold down the "Display" key and turn the dial until the required value appears
(in this case "ON").
Release "Display" to store your input.
Press "ENTER" to return to the next higher level.
Logamatic 2107 controls - We reserve the right to make any changes due to technical modifications.36
5
4
Heating circuit data
8
To Next Page
Loading...
Need help?
General
